Rem Rolling Block

robert garner · 09-02-2019, 12:22 PM

Any here rechamber or rebarrel a rolling block? I have one in a bottle neck 43 cal , that is in need of a chambering I can feed, recommendations ? perhaps a complete barrel change, what kinda money will we be talking about? Please don't worry about the rifle, it's been reblued and stock sanded smooth(not by me) would make a good shooter ifn it could be fed.

Bluntforce · 09-09-2019, 12:19 AM

.30-30?

Bluntforce · 09-27-2019, 11:52 PM

Here’s how one guy makes 11mm Mauser from .45-90.

https://www.youtube.com/watch?v=P7Lj51cgtVs

Hope it helps.

C&Rsenal and Mark their friendly gunsmith should be able to tell you how much a rebarreling would cost.

Czubek · 11-12-2019, 02:39 PM

I have a .43 Egyptian Rolling Block I was going to rechamber, but don't have the time to fart with it. I'll probably sell or trade it off.

Brian

09-02-2019, 12:22 PM	#1
robert garner Senior Member Join Date: Jun 2011 Location: hard by the chattahoochee Posts: 1,054	Rem Rolling Block Any here rechamber or rebarrel a rolling block? I have one in a bottle neck 43 cal , that is in need of a chambering I can feed, recommendations ? perhaps a complete barrel change, what kinda money will we be talking about? Please don't worry about the rifle, it's been reblued and stock sanded smooth(not by me) would make a good shooter ifn it could be fed. __________________ 3%

09-09-2019, 12:19 AM	#2
Bluntforce slug Join Date: Dec 2007 Posts: 15,166	.30-30? __________________

11-12-2019, 02:39 PM	#4
Czubek Moderator Join Date: May 2007 Location: Stover, Missouri Posts: 32,328	I have a .43 Egyptian Rolling Block I was going to rechamber, but don't have the time to fart with it. I'll probably sell or trade it off. Brian __________________ 3 Here at the Dirty Dozen's Bunker, we have no problems, only solutions.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-27-2019, 11:52 PM	#3
Bluntforce slug Join Date: Dec 2007 Posts: 15,166	Here’s how one guy makes 11mm Mauser from .45-90. https://www.youtube.com/watch?v=P7Lj51cgtVs Hope it helps. C&Rsenal and Mark their friendly gunsmith should be able to tell you how much a rebarreling would cost.